Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
hcom [2017/07/22 20:48]
ncc
hcom [2017/07/22 20:52] (current)
ncc
Line 35: Line 35:
   * On the Hunter ensure that the communications parameters are set as follows (type COMS at the DEMOS prompt to start the serial port configuration program):   * On the Hunter ensure that the communications parameters are set as follows (type COMS at the DEMOS prompt to start the serial port configuration program):
  
-<code>+<konsole><​nowiki>
 Transmission Parameters Transmission Parameters
 Rate - 2400     Prtcl - none    Pty - 8bit Rate - 2400     Prtcl - none    Pty - 8bit
Line 43: Line 43:
 Rate - 2400     Prtcl - none    Pty - 8bit Rate - 2400     Prtcl - none    Pty - 8bit
 RTS - off       DSR - n DCD - n T/O - n Serig - off RTS - off       DSR - n DCD - n T/O - n Serig - off
-</code>        ​+</nowiki></​konsole>        ​
  
   * On the Hunter, type the command ''​INP 999 HCOM.COM''​. The screen should now display Waiting.   * On the Hunter, type the command ''​INP 999 HCOM.COM''​. The screen should now display Waiting.
Line 54: Line 54:
 Start HCOM on the Husky Hunter 2 by running the HCOM command. The following screen will be displayed: Start HCOM on the Husky Hunter 2 by running the HCOM command. The following screen will be displayed:
  
-<code>+<konsole><​nowiki>
   :​========================================:​   :​========================================:​
   :  HUSKY File Transfer Utility ​  ​V1.0.1 ​ :   :  HUSKY File Transfer Utility ​  ​V1.0.1 ​ :
Line 63: Line 63:
  
               press ESC to exit.               press ESC to exit.
-</code>+</nowiki></​konsole>
  
 You can now connect to the Husky Hunter 2 using HCOM for Windows. You can now connect to the Husky Hunter 2 using HCOM for Windows.
  
 To exit the HCOM program press the <​key>​ESC</​key>​ key (<​key>​Shift + BRK</​key>​). ​ To exit the HCOM program press the <​key>​ESC</​key>​ key (<​key>​Shift + BRK</​key>​). ​