COMS¶
Command¶
COMS
Explanation¶
Initialise the communications parameters.
Examples¶
Two screens are used to select the communications parameters as follows:
------------------------------------------
| Transmission Parameters |
| |
| Rate-2400 Prtcl-none Pty-8bit |
| |
| CTS-n DTR-n LF-n Echo-n T/O-no Null- 0 |
| |
| press ENTER if acceptable. |
------------------------------------------
------------------------------------------
| Receiving Parameters |
| |
| Rate-2400 Prtcl-none Pty-8bit |
| |
| RTS-off DSR-n DCD-n T/O-no Serig-off |
| |
| press ENTER if acceptable. |
------------------------------------------
Remarks¶
See Communications for information on selecting communication parameters.
Note
Communication parameters are not reset when HUNTER is powered off.
In CP/M the serial communications interface is assigned the following logical devices:
Transmit: LST: PUN:
Receive: RDR: